How to use MagicResin's 4" Deep Pour & Casting Resin

Want to learn how to use our Table Top & Coating resin instead? Click here.

------

For optimal results, make sure that the temperature of the room and the resin is between 24-27c (75-81f).

Tip: If for any reason your bottles are cold, you can put them in warm water to accelerate the process.

 

A single pour should be no more than 4” of resin, else you will need to do multiple pours.

To purchase table top resin, check out our Table Top & Coating Resin.

STEP 1: MEASURE

Deep Pour 2A:1B Ratio

Into a mixing cup, pour twice the amount of resin (A) for each measurement of hardener (B) (2:1 ratio). Ex.: 500ml of resin (A) with 250ml of hardener (B).

STEP 2: MIX

Deep Pour Mix Step

Stir both parts together for 4-5 minutes. Make sure to scrap the sides while stirring. Once done, you have around 1 hour of working time.

STEP 3: POUR

Deep Pour Step 3

Make sure that your project is leveled and pour the resin on it.


Tip: 15 minutes after pouring, you can quickly pass a blow torch a few inches over the resin to pop air bubbles.

STEP 4: WAIT

Deep Pour Step 4

Your project will be tack-free after 3-4 days, and will be fully cured after 7 days. This curing time helps to release as many air bubbles as possible, and allows for deeper pours.

 

The remaining step is to enjoy your amazing creation!

Quality Assurance
Safe and Secure Checkout
Free Shipping in USA
24/7 Customer Support